← Content
Industry

Saudi Bus Ridership by City: What TGA's Q3 2026 Data Shows

Saudi bus ridership by city: the TGA reports more than 25.5 million passengers in Q3 2026. What the figures show and what operators should check.

Laetitia Montagne, Marketing Manager
· 7 min read · Updated

Saudi Arabia's Transport General Authority (TGA) reports more than 25.5 million public bus passengers across Saudi cities in the third quarter of 2026, a 3.6% increase on the third quarter of 2025, with Riyadh above 19.29 million. Compared with the first-quarter figures reported by the press, the national total is lower, and almost all of the gap sits in Makkah and Madinah. For an operator, a ridership series is only useful when the service data behind it, trips, kilometres and punctuality, can be produced alongside it.

What does the TGA report for Q3 2026?

On 16 November 2026 the Saudi daily Al Eqtisadiah reported, from a TGA statement, more than 25.5 million bus passengers in Q3 2026, up 3.6% on the same quarter of 2025. The city and regional breakdown it gives reads as follows:

City or regionQ3 2026 passengers (TGA)
Riyadhmore than 19.29 million
Makkahmore than 2.89 million
Jeddahmore than 1.19 million
Dammam Metropolitan Area and Qatif Governoratemore than 789,000
Madinahmore than 568,000
Qassim Regionmore than 266,000
Taif Governoratemore than 197,000
Al-Ahsa Governoratemore than 158,000
Jazan Regionmore than 107,000
Tabuk Regionmore than 53,000

The ten lines add up to about 25.5 million (our own sum), which matches the headline total. The Q3 figures cited here are passenger counts.

How do the Q3 figures compare with Q1 2026?

For the first quarter, we rely on press reports of the same TGA bulletin: SceneNow, dated 27 April 2026, and Zawya, whose headline gives the same total. SceneNow gives more than 30.6 million passengers for the quarter, with Riyadh at more than 19.55 million, Makkah at 4.87 million, Madinah at 3.4 million and Jeddah at 1.25 million. We could not read the Q1 bulletin itself, so treat the Q1 column below as reported by the press, not as a TGA publication.

City or regionQ1 2026 (press reports of the TGA bulletin)Q3 2026 (TGA)Change (our calculation)
Riyadh19.55 million19.29 million-1.3%
Makkah4.87 million2.89 million-40.7%
Madinah3.4 million568,000-83.3%
Jeddah1.25 million1.19 million-4.8%
Dammam and Qatif840,000789,000-6.1%
Qassim259,000266,000+2.7%
Taif180,000197,000+9.4%
Al-Ahsa134,000158,000+17.9%
Jazan118,000107,000-9.3%
Tabuk52,00053,000+1.9%

Every figure in the table is a "more than" figure, so the percentages are approximate. Makkah and Madinah together fall by about 4.8 million between the two quarters, out of a total fall of about 5.1 million, which is why the national total drops while Riyadh barely moves.

Why do Makkah and Madinah move so much between quarters?

Makkah and Madinah host the pilgrimage and visits to the two holy mosques, so an operator in either city would expect demand to follow the religious calendar. That is an expectation, not a finding of the TGA.

What the swing does show is that a single quarterly total hides the pattern that matters for planning. A network whose demand moves by tens of per cent between quarters needs timetables, duty rosters and information that follow the calendar. The Pysae platform page lists, for Network, calendars and exceptions such as summer timetables and public holidays, and, for Shift, a cyclic roster with automatic spread rules and labour regulation constraints.

How wide is the network behind these figures?

The Q3 breakdown lists ten cities or regions. A reader should check which units each line covers before comparing it with another source, because a list of ten cities and regions does not by itself say where else bus services run.

Our article on Europe's biggest public transport networks makes the same point for European ridership tables: state the metric, the perimeter and the period on every line.

What is the difference between ridership and service delivered?

A passenger count says how many people used the buses. It does not say how many trips were operated, how many kilometres were run, or whether buses were on time. An authority that publishes ridership by city will sooner or later be asked for the other half of the picture: passengers per trip, trips operated against trips planned, punctuality by line.

Those denominators come from the operator's vehicle data. The platform page lists, for Operations, a live map with delays, advances and regularity per line calculated automatically. For Fleet, it lists punctuality, mileage and journey time reports generated automatically from field data. The Operations module and the Fleet module pages cover these two products.

Passenger counts themselves come from a ticketing or counting system. An earlier Pysae article, Iris, passenger counting solution, connected to Pysae, describes one such connection.

What should an operator reconcile before using ridership figures?

Before a published ridership figure goes into a contract review, a business case or a board paper, check these points with the source:

  • Definition of a passenger. A boarding, a validated trip and a completed journey are different counts, so ask which one applies.
  • Period. Confirm that a quarter is a calendar quarter, and that the comparison quarter is built the same way.
  • Perimeter. Confirm which cities, governorates and services are inside each line of the table.
  • Rounding. "More than 19.29 million" is a floor, not a value. Differences of a few per cent between two such figures are not conclusive.
  • Matching service data. For each line of the table, have the trips operated and the kilometres run from the operator's own system for the same period.

For another Gulf example of a published headline figure that needs a baseline, see our article on early bus departures in Dubai.

What does this mean for operators in Gulf markets?

An authority that publishes city-level ridership every quarter creates a public series that operators, journalists and planners will compare over time. The operator's advantage is to hold the matching service data in the same structure: one record per trip, with the planned and actual passage times, the vehicle and the line. That record answers questions about reliability, mileage and the effect of calendar changes without a manual rebuild each quarter.

The Q3 2026 bulletin is a national summary. Local conditions, contract terms and reporting obligations differ by city.

Frequently asked questions

How many people used public buses in Saudi Arabia in Q3 2026?

According to the TGA news item dated 16 November 2026, more than 25.5 million public bus passengers in the third quarter of 2026, a 3.6% increase over the third quarter of 2025.

Which Saudi city has the most public bus passengers?

Riyadh, with more than 19.29 million passengers in Q3 2026 according to the TGA, ranked first.

Why is the Q3 total lower than the Q1 total?

Press reports of the TGA bulletin give more than 30.6 million for Q1 2026 against more than 25.5 million for Q3. In the city figures, Makkah and Madinah account for most of the gap. An operator should not assume a cause without asking the authority.

Are the Q1 and Q3 figures strictly comparable?

Not without checks. The Q1 figures come from press reports of the bulletin. Confirm the counting method, the definition of a passenger and the perimeter before drawing conclusions.

Does Pysae count passengers?

The platform page lists passenger information and a passenger app among its features. Passenger counting is covered by a connected solution described in an earlier article, linked above. Trips operated, kilometres and punctuality come from the Operations and Fleet modules.

To see how Operations and Fleet produce the service data that sits behind a ridership figure, use the "Request a demo" button on this page.